Wireless Temperature/Humidity Station. Davis Instruments Vantage Pro2 Plus, Vantage Pro2
Below you will find brief information for Wireless Temperature/Humidity Station Vantage Pro2 Plus, Wireless Temperature/Humidity Station Vantage Pro2. This manual describes how to install, configure, and use the Wireless Temperature/Humidity Station. You can learn about the station components, how to set the transmitter ID, how to choose a location for mounting, and how to connect the station to your wireless weather station console. There are also maintenance tips and troubleshooting information in this manual.
Advertisement
Advertisement
Advertisement
Key features
Wireless transmission
Temperature and humidity measurement
Radiation shield for accurate readings
Easy installation and setup
Compatible with Vantage Pro2 weather stations
Frequently asked questions
The range of the wireless transmission is up to 1000 feet (300 m) line of sight and 200 to 400 feet (75 to 150 m) through walls.
The station uses a CR-123 3-Volt Lithium cell battery.
You set the transmitter ID using DIP switches #1, 2 and 3, located on the SIM near the battery holder. The transmitter and receiver communicate with each other only when both are set to the same ID.
Use a pole having an outside diameter between 1" and 1-1/4" (25 – 31 mm). Hold the mounting bracket against the pole. Put two U-bolts around the pole and insert the ends through the holes in the back of the mounting bracket. Secure the mounting bracket using 1/4" flat washers and 1/4" hex nuts. Tighten all four sets of washers and hex nuts until the mounting bracket is firmly mounted on the pole. Next, install the SIM Shelter. While holding the shelter against the pole, place a U-bolt around the pole and through the two holes on at the top of the shelter. Place a flat washer, a lock washer and a hex nut on each of the bolt ends. Using an adjustable wrench or 7/16" wrench, tighten the nuts. Place the second U-bolt around the pole and through the two holes at the bottom of the shelter. Put a flat washer, a lock washer, and a hex nut on each bolt end, and tighten the hex nuts. Use 8”Cable Ties to secure sensor cable to pole to prevent fraying in wind.