Waterproof Cable Installation. ACTi E31, E34, E33, E32
Add to My manuals33 Pages
ACTi E31 is a 1MP bullet camera with day/night functionality, infrared illumination, basic wide dynamic range, and a fixed lens, making it suitable for various surveillance applications. Its compact and weatherproof design allows for flexible outdoor or indoor installation, and the Ethernet port enables seamless network connectivity. With its image enhancement features, the camera delivers clear and detailed footage even in challenging lighting conditions. The camera also supports Power over Ethernet (PoE), simplifying installation and eliminating the need for additional power outlets.
advertisement
![Waterproof Cable Installation. ACTi E31, E34, E33, E32 | Manualzz Waterproof Cable Installation. ACTi E31, E34, E33, E32 | Manualzz](http://s1.manualzz.com/store/data/001726008_1-383c32c477b1923a1bc6e5a79b92611e-360x466.png)
Hardware Manual
Waterproof Cable Installation
The camera and the pre-installed network cable are resistant to salt water, weak acid, alcohol, oil, grease and other common solvents. However, in areas with fierce weather conditions and those that can easily be flooded, ensure that the exposed length of cable is also protected.
It is recommended to use a flexible conduit with 1/2” diameter and the conduit gland (included in the package) to protect the camera cabling. In this case, the pre-installed network cable with
“pigtail” (female connector) must be replaced with a standard Ethernet cable
NOTE: The flexible conduit and Ethernet cable are not included in the package and must be sold separately. When purchasing, make sure the flex conduit size is 1/2" to match the bundled conduit gland.
To do the waterproof cable installation, also prepare the following tools:
Screwdriver
Wrench
advertisement
Related manuals
advertisement
Table of contents
- 6 Safety Instructions
- 7 List of Models
- 8 Package Contents
- 9 Physical Description
- 10 Mount the Camera
- 10 Using the Bundled Bracket
- 13 Other Mounting Options
- 14 Waterproof Cable Installation
- 15 installed Network Cable (“Pigtail”)
- 16 Step 2: Prepare the Conduit Gland and Flex Conduit
- 17 Step 3: Install the Ethernet Cable
- 18 Step 4: Connect the Ethernet Cable
- 19 Replace the Pre-Installed Network Cable
- 20 installed Network Cable (“Pigtail”)
- 21 Step 2: Install the New Ethernet Cable
- 23 Basic Connections
- 23 Connecting a Single Camera
- 24 Connecting Multiple Cameras
- 25 Configure the IP Addresses
- 25 Using DHCP Server to Assign IP Addresses
- 27 Using the Default Camera IP Address
- 29 Access the Camera