installed Network Cable (“Pigtail”). ACTi E31, E34, E33, E32

Add to My manuals
33 Pages

advertisement

installed Network Cable (“Pigtail”). ACTi E31, E34, E33, E32 | Manualzz

Hardware Manual

Step 1: Remove the Pre-installed Network C able (“Pigtail”)

1.

Loosen the three (3) screws to detach the back cover.

NOTE: A cable is connected inside the camera; do not abruptly pull the back cover.

2.

Disconnect the network connector (A) and remove the sealing nut (B).

(A)

(B)

3.

Pull out the network cable from the back cover and disassemble the parts as marked below.

Seal Claw Sealing Nut

4.

Squeeze the seal to pull out the connector and then completely remove the seal, claw, and sealing nut from the network cable.

20 www.acti.com

advertisement

Related manuals