Printing Only with White Ink. Roland XR-640

Chapter 3 Printing









3-1 Print Job Setting : Equipped with White & Silver

Click .

For [Media Type], select either "Generic

Clear Film [MT]" or "xxx [MT] : PET Clear

Film, Adhesive".

* “xxx” indicates “SP-CLT” and others.

For [Print Quality], select either [High

Quality (Layered)] or [Standard (Layered)].

For [Mode], select [CMYKLcLm (v)-> Mt].

Click .

Turn on the [Convert Spot Color] option.

Click .

In [Operation Mode], select the operation of the printer.

Chapter 3 Printing

29

3-1 Print Job Setting : Equipped with White & Silver

When You Want to Display the Side Opposite the Printed Surface by Using Clear Film.

Click .

Turn on the [Mirror] option.

When the printing data with mirror image is prepared beforehand, you do not need to turn on this option.

 Click [OK] to close the "Queue A Properties" window.

This is the end of the print job setting. To start printing, go on to page 53 “Starting the Print Operation.”

* Only the settings necessary for the use of the metallic silver ink are described in this section. For other settings, refer to the online help provided for VersaWorks.

Printing Only with White Ink

This section describes how to perform printing only with the white ink. To use the while ink in printing, you need to use the printing data where the use of the white ink is designated. If the printing data have the portion designating the use of other colors, with the setting described in this section, you can print with the white ink only the area of the image which has been designated to print with the white ink.

 P. 12, “2-3 Creating Printing Data”

Procedure

 Make sure that you have finished making the preparations for VersaWorks, getting the

printer ready, and creating the printing data ( page 9, "Chapter 2 -- Getting Ready").

30

Chapter 3 Printing Chapter 3 Printing