advertisement
Trouble Recovery
Q. Is fuel joint connection incorrect?
A. Connect correctly.
Q. Is heat range of spark plug incorrect?
A. Inspect spark plug and replace it with recommended type.
trailering. Damage could make the outboard motor unsafe to operate.
If the outboard motor hits an object in the water, follow the procedure below.
Q. Is high pressure fuel pump drive belt broken?
A. Have serviced by a Yamaha dealer.
Q. Is engine not responding properly to shift lever position?
A. Have serviced by a Yamaha dealer.
Engine vibrates excessively.
Q. Is propeller damaged?
A. Have propeller repaired or replaced.
Q. Is propeller shaft damaged?
A. Have serviced by a Yamaha dealer.
Q. Are weeds or other foreign matter tangled on propeller?
A. Remove and clean propeller.
Q. Is motor mounting bolt loose?
A. Tighten bolt.
Q. Is steering pivot loose or damaged?
A. Tighten or have serviced by a Yamaha dealer.
EMU29433
Temporary action in emergency
EMU29440
Impact damage
EWM00870
WARNING
The outboard motor can be seriously damaged by a collision while operating or
1.
Stop the engine immediately.
2.
Inspect the control system and all components for damage. Also inspect the boat for damage.
3.
Whether damage is found or not, return to the nearest harbor slowly and carefully.
4.
Have a Yamaha dealer inspect the outboard motor before operating it again.
EMU29463
Replacing fuse
If the fuse has blown on an electric start model, open the fuse holder and replace the fuse with a new one of the proper amperage.
EWM00631
WARNING
Substituting an incorrect fuse or a piece of wire could allow excessive current flow. This could cause electric system damage and a fire hazard.
72
advertisement
Related manuals
advertisement
Table of contents
- 7 Safety information
- 7 Outboard motor safety
- 7 Propeller
- 7 Rotating parts
- 7 Hot parts
- 7 Electric shock
- 7 Power trim and tilt
- 7 Engine shut-off cord (lanyard)
- 7 Gasoline
- 8 Gasoline exposure and spills
- 8 Carbon monoxide
- 8 Modifications
- 8 Boating safety
- 8 Alcohol and drugs
- 8 Personal flotation devices
- 8 People in the water
- 8 Passengers
- 8 Overloading
- 9 Avoid collisions
- 9 Weather
- 9 Accident reporting
- 9 Boat education and training
- 10 Passenger training
- 10 Boating safety publications
- 10 Laws and regulations
- 10 Boating organizations
- 10 road)
- 11 sound signals
- 11 Rules when encountering vessels
- 12 Other special situations
- 15 General information
- 15 Identification numbers record
- 15 Outboard motor serial number
- 15 Key number
- 16 Read manuals and labels
- 16 Warning labels
- 19 requirements
- 19 Specifications
- 20 Installation requirements
- 20 Boat horsepower rating
- 20 Mounting motor
- 20 Remote control requirements
- 20 Battery requirements
- 20 Specifications of Battery
- 20 Mounting battery
- 21 Multiple batteries
- 21 Propeller selection
- 21 Start-in-gear protection
- 21 Engine oil requirements
- 22 Fuel requirements
- 22 Gasoline
- 22 Ring Free Fuel Additive
- 23 Muddy or acidic water
- 23 Anti-fouling paint
- 23 Motor disposal requirements
- 23 Emission control information
- 23 North American models
- 25 Components
- 25 Components diagram
- 25 Remote control box
- 26 Remote control lever
- 26 Neutral interlock trigger
- 26 Neutral throttle lever
- 27 Choke switch
- 27 Throttle friction adjuster
- 28 Choke knob for pull type
- 28 Main switch
- 28 remote control
- 29 bottom engine cowling
- 29 Trim tab with anode
- 30 and tilt model
- 30 Top cowling release lever
- 31 Flushing device
- 32 Instruments and indicators
- 32 Digital tachometer
- 32 Trim meter
- 32 Hour meter
- 32 Oil level indicator (digital type)
- 33 Overheat-alert indicator
- 33 Digital speedometer
- 33 Speedometer
- 34 Fuel gauge
- 34 Trip meter / Clock / Voltmeter
- 35 Fuel level-alert indicator
- 35 indicator
- 35 Analog tachometer
- 35 indicators 2)
- 36 Analog trim meter
- 37 Engine control system
- 37 Alert system
- 37 Overheat alert
- 37 alert
- 39 Installation
- 39 Mounting the outboard motor
- 41 Operation
- 41 First-time operation
- 41 Breaking in engine
- 41 Getting to know your boat
- 41 Checks before starting engine
- 42 Fuel level
- 42 Remove cowling
- 42 Fuel system
- 42 Controls
- 43 Engine shut-off cord (lanyard)
- 43 Engine
- 43 storage
- 43 Flushing device
- 44 Install cowling
- 44 system
- 45 Battery
- 46 Filling fuel and engine oil
- 46 fuel joint
- 46 Filling oil
- 48 Oil level indicator operation
- 49 Operating engine
- 49 Feeding fuel
- 49 Starting engine
- 51 Checks after starting engine
- 51 Cooling water
- 51 Warming up engine
- 51 Choke start models
- 51 Checks after engine warm-up
- 51 Shifting
- 51 Stop switches
- 52 Shifting
- 53 Stopping boat
- 53 Stopping engine
- 53 Procedure
- 53 Trimming outboard motor
- 54 and tilt)
- 54 Adjusting boat trim
- 55 Tilting up and down
- 56 and tilt models)
- 57 trim and tilt models)
- 57 Shallow water
- 57 Power trim and tilt models
- 58 Cruising in other conditions
- 59 Maintenance
- 59 outboard motor
- 59 Storing outboard motor
- 59 Procedure
- 60 Lubrication (oil injection models)
- 61 measures
- 61 Flushing power unit
- 62 Cleaning the outboard motor
- 62 motor
- 62 Periodic maintenance
- 63 Replacement parts
- 63 Maintenance interval guidelines
- 64 Maintenance chart
- 67 Greasing
- 68 Checking fuel filter
- 68 Inspecting idling speed
- 69 Checking water in engine oil tank
- 69 Checking wiring and connectors
- 69 Checking propeller
- 70 Removing propeller
- 70 Installing propeller
- 71 Changing gear oil
- 72 anode(s)
- 73 models)
- 73 Connecting the battery
- 74 Disconnecting the battery
- 75 Trouble Recovery
- 75 Troubleshooting
- 78 Temporary action in emergency
- 78 Impact damage
- 78 Replacing fuse
- 79 operate
- 79 Starter will not operate
- 80 Emergency starting engine
- 81 Engine fails to operate
- 81 Low oil level alert activates
- 82 Top cowling does not unlock
- 82 Treatment of submerged motor
- 83 Consumer information
- 83 for U.S.A. and Canada
- 85 YEAR LIMITED WARRANTY
- 88 THE USA OR CANADA