advertisement
Basic components
1
ZMU03595 ZMU05095
EMU26372
Top cowling lock lever(s) (turn type)
To remove the engine top cowling, turn the lock lever(s) and lift off the cowling. When installing the cowling, check to be sure it fits properly in the rubber seal. Then lock the cowling again by returning the lever(s) to the lock position.
1. Flushing device
EMU31702
Water separator
This engine has a combination fuel filter/water separator and associated warning system. If water separated from the fuel exceeds a specific volume, the warning device will activate.
1
ZMU05093
ZMU05474
1. Top cowling lock lever(s)
EMU26460
Flushing device
This device is used to clean the cooling water passages of the motor using a garden hose and tap water.
NOTE:
For details on usage, see page 56.
Activation of warning device
● The water separator warning indicator will blink.
● The buzzer will sound intermittently only when the gear shift is in neutral.
● If the warning system has activated, stop the engine and consult a Yamaha dealer immediately.
EMU26470
Tachometer
This gauge shows the engine speed and has the following functions.
21
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 7 General information
- 7 Identification numbers record
- 7 Outboard motor serial number
- 7 Key number
- 7 Emission control information
- 7 North American models
- 8 Star labels
- 9 Safety information
- 10 Important labels
- 10 Warning labels
- 11 Caution labels
- 11 (Rules of the road)
- 11 sound signals
- 12 Rules when encountering vessels
- 13 Other special situations
- 14 Fueling instructions
- 15 Gasoline
- 15 Engine oil
- 16 Battery requirement
- 16 Battery specifications
- 16 Propeller selection
- 17 Start-in-gear protection
- 18 Basic components
- 18 Main components
- 19 Fuel tank
- 19 Fuel joint
- 20 Fuel gauge
- 20 Fuel tank cap
- 20 Air vent screw
- 20 Remote control
- 20 Remote control lever
- 20 Neutral interlock trigger
- 20 Neutral throttle lever
- 21 Tiller handle
- 21 Gear shift lever
- 21 Throttle grip
- 21 Throttle indicator
- 22 Throttle friction adjuster
- 22 Engine stop lanyard switch
- 23 Engine stop button
- 23 Main switch
- 24 Steering friction adjuster
- 24 remote control or tiller handle
- 25 bottom engine cowling
- 25 Variable trolling RPM switches
- 26 Trim tab with anode
- 26 and tilt or hydro tilt model
- 27 (turn type)
- 27 Flushing device
- 27 Water separator
- 27 Tachometer
- 28 Digital tachometer
- 28 indicator
- 29 Overheat warning indicator
- 29 (digital type)
- 29 Speedometer (digital type)
- 30 Trim meter
- 30 Trim meter (digital type)
- 30 Hour meter (digital type)
- 31 Trip meter
- 31 Clock
- 32 Fuel gauge
- 32 Fuel warning indicator
- 32 indicator
- 33 meters
- 33 Tachometer unit
- 36 Speed & fuel meter unit
- 37 Speedometer unit
- 38 Fuel management meter
- 39 Warning system
- 39 Overheat warning
- 39 Low oil pressure warning
- 41 Operation
- 41 Installation
- 41 Mounting the outboard motor
- 42 Breaking in engine
- 42 Procedure for 4-stroke models
- 42 Preoperation checks
- 43 Controls
- 43 Engine
- 43 Checking the engine oil level
- 43 Filling fuel
- 44 Ring Free Fuel Additive
- 44 Operating engine
- 44 Feeding fuel (portable tank)
- 45 Starting engine
- 48 Warming up engine
- 48 models
- 48 Shifting
- 48 control models)
- 49 and power trim and tilt models)
- 50 Trolling
- 50 Adjusting trolling speed
- 50 Stopping engine
- 50 Procedure
- 51 Trimming outboard motor
- 51 Adjusting trim angle
- 52 Adjusting boat trim
- 53 Tilting up and down
- 54 power tilt models)
- 56 Cruising in shallow water
- 56 power tilt models
- 57 Cruising in other conditions
- 58 Maintenance
- 58 Specifications
- 59 motor
- 60 Storing outboard motor
- 60 Procedure
- 61 Lubrication
- 61 measures
- 62 Battery care
- 62 Flushing power unit
- 63 Cleaning the outboard motor
- 63 motor
- 64 Periodic maintenance
- 64 Replacement parts
- 65 Maintenance chart
- 66 Maintenance chart (additional)
- 67 Greasing
- 68 Checking fuel system
- 69 Inspecting idling speed
- 69 Changing engine oil
- 71 Checking wiring and connectors
- 71 Exhaust leakage
- 71 Water leakage
- 71 Engine oil leakage
- 71 power tilt system
- 72 Checking propeller
- 73 Removing the propeller
- 73 Installing the Propeller
- 74 Changing gear oil
- 75 Cleaning fuel tank
- 75 anode(s)
- 76 models)
- 77 Connecting the battery
- 78 Disconnecting the battery
- 78 Checking top cowling
- 78 Coating the boat bottom
- 79 Trouble Recovery
- 79 Troubleshooting
- 82 Temporary action in emergency
- 82 Impact damage
- 82 Replacing fuse
- 83 not operate
- 83 blinks while cruising
- 85 Starter will not operate
- 86 Emergency starting engine
- 86 Treatment of submerged motor
- 87 Procedure
- 88 Consumer information
- 88 U.S.A. and Canada
- 90 WARRANTY
- 92 THE USA OR CANADA