Turning On/Off. Jensen JE1507, JE1507DC

Basic Operation

Turning On/Off

Turning On

First, connect the power correctly..

Press on the TV or POWER on the remote control.

Never attempt to move the TV unless the power cord has been disconnected.

Turning Off

Press on the TV or POWER on the remote control.

The TV enters standby mode and the image on the screen disappears.

The TV will still consume some power as long as the power cord is still inserted into the power outlet.

If you are not going to use this TV for a long period of time, be sure to remove the power cord from the power outlet.

Viewing Channels

Selecting an Antenna

Input Source

Before you begin watching television, you must first select the antenna source and allow the television to perform auto programming.

1. Press the MENU button on the remote control.

2. Press the ◄ / ► to select the CHANNEL menu.

3. Press▼to access and [Antenna] item will be highlighted.

4. Press the ◄ / ► to select [Air] or [Cable] according to what kind of connection is made with your TV.

5. Press▼to select [Auto Scan] and ► to confirm and



 continue.

If you choose [Air], please select [Start to Scan] item and press ► to confirm, then the TV starts Auto Program automatically.

If you choose [Cable], there are 3 kinds of Cable systems, including STD, IRC and HRC. Select [Auto] if unsure.

(When you select [Auto], the unit automatically detects the proper cable source. If the unit fails to detect the type of cable system, please consult with your cable TV company to determine the proper system and enter this information.) Then please select [Start to Scan] item and press ► to confirm, the TV starts Auto Program automatically.

DTV signal

6. During the process of the auto search, you can press MENU or EXIT to exit.

Auto Programming

Operate according to the steps 1-5 above , the unit automatically begins auto program. Auto Program may take a while to complete and a progress bar is displayed while available channels are being scanned. If you select [MENU] or

[EXIT] to cancel the Auto Program before all receivable channels are scanned, you should run Auto Program at a later time to be sure all available channels are received. Auto Program will create a list of receivable channels for the current input. You will be required to run Auto Program for RF input to create a list of available channels.

22