THE BATTERY MODULE. Ever Superline 11, 3 x 28 x 7Ah, Superline 11, 1 x 28 x 7Ah, Poweline 11, 2 x 28 x 7Ah

Instruction Manual for SUPERLINE series battery back-ups

THE BATTERY MODULE

Battery back-ups from the SUPERLINE series offer the option of connecting additional battery modules. Modules are connected to connection clamps located on the rear panel of the battery back-up. Connecting battery modules extends the time of battery operation mode. Battery modules are installed in a series and are safeguarded with additional cut-offs located on their rear panels.

WARNING! If the fuses burn out, they should be replaced in accordance with the specification.

Connecting the modules

Figure 11: Connecting battery modules

WARNING! With the safeguards active there is hazardous, and possibly lethal, voltage on the connection clamps. Disable all safeguards before commencing any installation works!

1. Turn off the battery back-up via the user interface (KONTROLA 1/4; UPS).

2. Switch the F3 and F4 circuit breakers to OFF.

3. Disable all accumulator safeguards (F1, F2 and F5) by opening the fuse holders. There is no fixed order to do this. Remove the fuse-elements.

4. Disable all accumulator safeguards for the already connected battery modules and those being connected by opening the fuse holders and removing the fuseelements.

5. Disable the safeguards of the basic and BYPASS lines on the switchboard of the room/building.

6. Remove the protective stoppers from connectors (rear panels of the battery back-up and modules).

7. Connect the module to the battery back-up, ensuring correct terminal polarity.

Modules are connected in a series: UPS to first module, then first module to second module, second module to third module and so on. Protective earthing cables from each device are connected to a common point in the room’s/building’s switching station.

2010/01/13 www.ever.eu

23