advertisement
▼
Scroll to page 2
of
52
advertisement
Related manuals
advertisement
Table of contents
- 1 HP StorageWorks 60 Modular Smart Array Enclosure User Guide
- 2 Notice
- 3 Contents
- 6 Component identification
- 6 Front panel LEDs and buttons
- 7 Rear panel components
- 7 Dual 7-segment display board
- 8 Rear panel LEDs and buttons
- 9 SAS and SATA device numbers
- 9 SAS and SATA hard drive LEDs
- 9 SAS and SATA hard drive LED combinations
- 11 Operations
- 11 Power up
- 11 Power down the server
- 13 Setup
- 13 Rack planning resources
- 13 Optimum environment
- 13 Space and airflow requirements
- 14 Temperature requirements
- 14 Power requirements
- 15 Electrical grounding requirements
- 15 Rack warnings
- 15 Shipping contents
- 16 Rack mounting hardware kit contents
- 16 Converting rails for round-hole racks
- 17 Installing a storage enclosure into the rack
- 19 Installing hardware options
- 19 Installing servers
- 20 Choosing a configuration
- 20 Single-enclosure configuration
- 21 Cascading (1+1) configuration
- 21 Cabling the storage enclosure
- 21 SAS cabling guidelines
- 21 Supported cables
- 22 Power cords
- 22 Updating firmware
- 23 Hardware options installation
- 23 Hard drive options
- 23 SAS and SATA hard drive guidelines
- 23 SAS or SATA hard drive
- 25 Configuration and utilities
- 25 Configuration tools
- 25 Array Configuration Utility
- 25 Option ROM Configuration for Arrays
- 26 Smart Components for ROM Flash
- 26 Management tools
- 26 HP Systems Insight Manager
- 26 Management Agents
- 26 Diagnostic tools
- 26 Integrated Management Log
- 27 Array Diagnostic Utility
- 27 Remote support and analysis tools
- 27 Open Services Event Manager
- 27 Keeping the system current
- 27 Change control and proactive notification
- 27 Care Pack
- 28 Troubleshooting
- 28 When the storage enclosure does not start
- 29 Diagnostic questions
- 29 Are the power supply/system fan LEDs green?
- 29 Is the system power LED green?
- 29 Recognizing hard drive failure
- 30 Effects of a hard drive failure
- 30 Compromised fault tolerance
- 30 Recovering from compromised fault tolerance
- 30 Factors to consider before replacing hard drives
- 31 Automatic data recovery (rebuild)
- 31 Time required for a rebuild
- 32 Failure of another drive during rebuild
- 32 Drive failure in a NetWare environment
- 32 Failed drives or interim recovery mode
- 33 Handling disk drive failures
- 34 Regulatory compliance notices
- 34 Regulatory compliance identification numbers
- 34 Federal Communications Commission notice
- 34 FCC rating label
- 35 Class A equipment
- 35 Class B equipment
- 35 Declaration of conformity for products marked with the FCC logo, United States only
- 36 Modifications
- 36 Cables
- 36 Canadian notice (Avis Canadien)
- 36 European Union regulatory notice
- 37 Disposal of waste equipment by users in private households in the European Union
- 37 Japanese notice
- 37 BSMI notice
- 38 Korean notice
- 38 Power cord statement for Japan
- 39 Electrostatic discharge
- 39 Preventing electrostatic discharge
- 39 Grounding methods to prevent electrostatic discharge
- 40 Specifications
- 40 Environmental specifications
- 40 Storage enclosure specifications
- 41 Technical support
- 41 Before you contact HP
- 41 HP contact information
- 41 Customer Self Repair
- 49 Acronyms and abbreviations
- 51 Index