advertisement
Specifications
In this section
Environmental specifications
Specification Value
Temperature range
Operating* 10 ° C to 35 ° C (50 ° F to 95 ° F)
Maximum rate of change is 10º C/hr (18º F/hr)
Storage
Relative humidity**
Operating
-30°C to 60°C (-22°F to 140°F)
Maximum rate of change is 20º C/hr (36º F/hr)
Storage
Altitude ‡
10% to 90% relative humidity (Rh), 28º C (82.4º F) maximum wet bulb temperature, non-condensing
5% to 95% relative humidity (Rh), 38.7º C (101.66º F) maximum wet bulb temperature, non-condensing
Operating 3048 m (10,000 ft)
This value may be limited by the type and number of options installed.
Non-operating 9144 m (30, 000 ft)
* Temperature ratings shown are for sea level. An altitude derating of 1°C per 300 m (1.8°F per 1,000 ft) to 3048 m (10,000 ft) is applicable. No direct sunlight allowed. The upper limit may be limited by the type and number of options installed.
** Storage maximum humidity of 95% is based on a maximum temperature of 45°C (113°F). Altitude maximum for storage corresponds to a pressure minimum of 70 KPa.
‡ Maximum allowable altitude change rate is 457 m/min (1500 ft/min).
Storage enclosure specifications
Specification Value
Height 8.8 cm (3.47 in)
Depth
Width
59 cm (23.25 in)
44.80 cm (17.64 in)
Weight (maximum) 24.6 kg (54 lb)
Weight (no drives installed) 15.42 kg (34 lb)
Specifications 40
advertisement
Related manuals
advertisement
Table of contents
- 1 HP StorageWorks 60 Modular Smart Array Enclosure User Guide
- 2 Notice
- 3 Contents
- 6 Component identification
- 6 Front panel LEDs and buttons
- 7 Rear panel components
- 7 Dual 7-segment display board
- 8 Rear panel LEDs and buttons
- 9 SAS and SATA device numbers
- 9 SAS and SATA hard drive LEDs
- 9 SAS and SATA hard drive LED combinations
- 11 Operations
- 11 Power up
- 11 Power down the server
- 13 Setup
- 13 Rack planning resources
- 13 Optimum environment
- 13 Space and airflow requirements
- 14 Temperature requirements
- 14 Power requirements
- 15 Electrical grounding requirements
- 15 Rack warnings
- 15 Shipping contents
- 16 Rack mounting hardware kit contents
- 16 Converting rails for round-hole racks
- 17 Installing a storage enclosure into the rack
- 19 Installing hardware options
- 19 Installing servers
- 20 Choosing a configuration
- 20 Single-enclosure configuration
- 21 Cascading (1+1) configuration
- 21 Cabling the storage enclosure
- 21 SAS cabling guidelines
- 21 Supported cables
- 22 Power cords
- 22 Updating firmware
- 23 Hardware options installation
- 23 Hard drive options
- 23 SAS and SATA hard drive guidelines
- 23 SAS or SATA hard drive
- 25 Configuration and utilities
- 25 Configuration tools
- 25 Array Configuration Utility
- 25 Option ROM Configuration for Arrays
- 26 Smart Components for ROM Flash
- 26 Management tools
- 26 HP Systems Insight Manager
- 26 Management Agents
- 26 Diagnostic tools
- 26 Integrated Management Log
- 27 Array Diagnostic Utility
- 27 Remote support and analysis tools
- 27 Open Services Event Manager
- 27 Keeping the system current
- 27 Change control and proactive notification
- 27 Care Pack
- 28 Troubleshooting
- 28 When the storage enclosure does not start
- 29 Diagnostic questions
- 29 Are the power supply/system fan LEDs green?
- 29 Is the system power LED green?
- 29 Recognizing hard drive failure
- 30 Effects of a hard drive failure
- 30 Compromised fault tolerance
- 30 Recovering from compromised fault tolerance
- 30 Factors to consider before replacing hard drives
- 31 Automatic data recovery (rebuild)
- 31 Time required for a rebuild
- 32 Failure of another drive during rebuild
- 32 Drive failure in a NetWare environment
- 32 Failed drives or interim recovery mode
- 33 Handling disk drive failures
- 34 Regulatory compliance notices
- 34 Regulatory compliance identification numbers
- 34 Federal Communications Commission notice
- 34 FCC rating label
- 35 Class A equipment
- 35 Class B equipment
- 35 Declaration of conformity for products marked with the FCC logo, United States only
- 36 Modifications
- 36 Cables
- 36 Canadian notice (Avis Canadien)
- 36 European Union regulatory notice
- 37 Disposal of waste equipment by users in private households in the European Union
- 37 Japanese notice
- 37 BSMI notice
- 38 Korean notice
- 38 Power cord statement for Japan
- 39 Electrostatic discharge
- 39 Preventing electrostatic discharge
- 39 Grounding methods to prevent electrostatic discharge
- 40 Specifications
- 40 Environmental specifications
- 40 Storage enclosure specifications
- 41 Technical support
- 41 Before you contact HP
- 41 HP contact information
- 41 Customer Self Repair
- 49 Acronyms and abbreviations
- 51 Index