Selecting a preset radio station. Philips FWD570/21A, FWD570/21M, FWD570

Tuner Operations

Manual preset programming

1

Press TUNER (BAND) repeatedly to select the desired tuner band: FM or MW.

2

Press and hold

1 / ¡ on the system or on the remote control to search a radio frequency.

3

Press PROGRAM.

➜ “

PROG” and “01” will display.

4

Press O / P or numeric keys (0-9) to select the desired preset number.

5

After selecting an address number, press

PROGRAM again to store the radio station.

● Repeat steps 3-5 to store other preset radio stations.

To stop storing the manual preset

● Press

7 on the system.

Note:

– If you attempt to store more than 40 preset radio stations, “FULL” will be displayed.

Changing tuning grid

In some countries, the frequency step between adjacent channels in the MW band is 9 kHz (10 kHz in some areas). The preset frequency step in the factory is 9 kHz.

1

Plug the AC power cord.

2

Press TUNER to select MW mode.

3

Press and hold 9 for more than 3 seconds.

➜ “

STEP XX K” appears.

Note:

– All preset stations will be lost and need to be reprogrammed.

Selecting a preset radio station

● In tuner mode, press O / P or use the

numeric keys (0-9) to select the desired preset number.

➜ The preset number, radio frequency, and waveband are displayed.

Deleting a preset radio station

1

Press O or P to select the preset radio station to be erased.

2

Press

7 on the system, “PRESET DELETED” appears on the display.

➜ The preset numbers of all other preset radio stations in the band with higher numbers are also decreased by one.

● Repeat steps 1-2 to erase other preset radio stations.

38