advertisement
Section 2A
Installing the Software
Installing the Software and Drivers
1. Insert the installation CD into your CD-ROM drive. The CD should launch automatically. Click
Setup to continue. (If autoplay is disabled, navigate to your CD-ROM drive in Explorer and click setup .exe
.)
2. In the “Welcome to the InstallShield Wizard for
Sprint SmartView” installation window, click
Next .
3. Read the License Agreement and select “ I accept the terms in the License Agreement agree to the terms. Click Next .
” to
4. Select a skin (“New” or “Classic”) and click
Next .
6 Section 2A . Installing the Software
5. In the “Destination Folder” window, click Next to accept the default installation folder
(recommended); or click Change , specify a different installation folder, and then click Next to continue.
8. If a message that you must restart your computer is displayed, click Yes to restart your computer. Wait until your computer restarts.
9. Proceed to Activating Your USB Modem .
6. Click Install to begin installation.
7. When the “InstallShield Wizard Completed” window appears, click Finish .
Section 2A . Installing the Software 7
advertisement
Related manuals
advertisement
Table of contents
- 9 USB Modem
- 10 Your Sprint 3G/4G USB Modem
- 11 System Requirements
- 11 Package Contents
- 11 Care and Maintenance
- 13 USB Modem
- 14 2A . Installing the Software
- 14 Installing the Software and Drivers
- 16 2B . Using Your USB Modem
- 16 Launch Software
- 16 Activating Your USB Modem
- 17 Attaching the Y-Extension Cable
- 18 Laptop Clip
- 18 Viewing the User Guide
- 19 Removing the USB Modem
- 19 Contacting Sprint Customer Service
- 19 Troubleshooting
- 21 and Warranty
- 22 3A . Technical Specifications
- 22 Software Specifications
- 22 Environmental Specifications
- 22 Mechanical Specifications
- 23 CDMA LED Operation
- 23 WiMAX LED Operation
- 24 3B . Regulatory Information
- 25 Trademarks
- 25 Copyright
- 26 3C . Important Safety Information