Benutzerhandbuch

4 Operating the device

4.10 Transmitting values

A data connection sends the value measured to your online logbook at www.bodytel.com via your mobile phone. If previous measurements have not been transmitted, all unsent values will be transmitted together.

When data are being sent via Bluetooth ® , “ C02 ” will be shown on your PressureTel ™ . After a successful transmission the blood pressure monitor will emit a brief acoustic signal

(1 x beep). After each blood pressure measurement the value is transmitted automatically.

If necessary, values can also be transmitted manually. Therefore, press the right button (MENU) of the monitor (first time: long), until “ C02 ” flashes. Then press the left button (START/

STOP) button once. “ C02 ” stops flashing and the stored values are transmitted. i Attention: To transmit data form the PressureTel ™ to your mobile phone, the BodyTel Mobile application must be opened.

4.11 Deleting stored values

If you press the left button (START/STOP) for longer than 5 seconds an acoustic signal will be emitted and the display will show “ Clr ”.

If you press the left button for further 5 seconds, all previously stored values will be deleted and the time mode will reappear.

37

Handbuch-Rev.21.07.10_Deutsch-Englisch.indd 37 21.07.2010 10:11:33