WantecDTL

2 Informationen

Important information

The wantecDTL is a DECT-standard cordless adapter for universal usage when operating analogue terminals on GAP-compatible DECT systems.

Essentially a ”cordless extension cable”, the wantecDTL eliminates the need for complicated cabling work and can be registered on any standard

DECT/GAP base station just like an extra cordless handset. The wantecDTL can be used to connect analogue telephones, fax machines, answering machines, entrance intercoms and modems to your DECT base station.

The device must use DTMF dialling (voice frequency signalling); terminals that only support pulse dialling cannot be used on the wantecDTL. If your device uses pulse dialling, please check if it can also be switched over to

DTMF dialling.

The wantecDTL 300 features an integrated aerial and has a standard

DECT range of up to 30 m indoors and up to 300 m out of doors.

An external aerial must be connected to the wantecDTL 5000. Much greater distances may be covered, depending on the base station used, the aerial and the general environmental conditions. By using an external aerial on the base station or a DECT repeater with an external directional aerial, a maximum range of up to 10 km can be attained.

To ensure optimal operation on different base stations, it may be necessary to modify the wantecDTL by setting various parameters on the base station. For more information, see the ”Programming mode” chapter. The varying functionalities of different base stations may, in turn, result in variations in operation. Please observe the instructions for operating your base station.

NOTE

The factory setting on the wantecDTL is for operation on a base station with an ISDN connection, which means that in many cases it will not require any further modification. For operation on base stations with an analogue telephone connection, you will need to switch over parameter 40 in programming mode.