WantecDTL

NOTE

NOTE

Example

2 Registration / programming 7

2.2.1

Activating programming mode

Proceed as follows to change the wantecDTL to programming mode:

1.

Connect your telephone to the wantecDTL.

2.

Connect the power supply unit to your wantecDTL.

3.

Plug the power supply unit into a power socket. Leave the phone on the hook for at least 30 seconds.

4.

Lift the handset on your telephone. Depending on whether or not your wantecDTL is already registered on a base station, you will either hear a busy tone or a dialling tone.

5.

On your telephone, enter * * 9 .

6.

You will hear a positive acknowledgement tone.

7.

Optional step: Enter the PIN for the wantecDTL via your telephone.

The PIN only needs to be entered if a new PIN has been set up beforehand in programming mode.

Access to programming mode can be protected using the PIN!

8.

You will hear the special dialling tone indicating that programming mode is active.

You can now enter the parameter codes to change the relevant features of your wantecDTL.

Let’s say, for example, you want to use your wantecDTL on a base station with an ISDN telephone connection. Activate programming mode as described above in points 1-8 and then proceed as follows:

1.

Enter the programming code for ”Connection to an ISDN/analogue Line” :

4 0

.

2.

To activate the feature, enter

0 #

.

3.

You will hear a positive acknowledgement tone, followed by the special dialling tone once more. The feature is now active.