advertisement
SpeedClean™ 2800 PSI Pressure Washer
TROUBLESHOOTING
Problem Cause
1.
Low pressure spray tip installed.
2.
Water inlet is blocked.
3.
Inadequate water supply.
4.
Inlet hose is kinked or leaking.
5.
Clogged inlet hose strainer.
Pump has following problems: failure to produce pressure, erratic pressure, chattering, loss of pressure, low water volume.
Detergent fails to mix with spray.
6.
Water supply is over 100°F.
7.
High pressure hose is blocked or leaks.
8.
Gun leaks.
9.
Spray tip is obstructed.
10. Pump is faulty.
1.
Detergent siphoning tube is not submerged.
2.
Chemical filter is clogged or cracked.
3.
Dirty in-line filter.
4.
High pressure spray tip installed.
Engine shuts down during operation.
Out of gasoline.
Correction
1.
Replace spray tip with high pressure spray tip.
2.
Clear inlet.
3.
Provide adequate water flow.
4.
Straighten inlet hose, patch leak.
5.
Check and clean inlet hose strainer.
6.
Provide cooler water supply.
7.
Clear blocks in outlet hose.
8.
Replace gun.
9.
Clean spray tip.
10. Contact Authorized service facility.
1.
Insert detergent siphoning tube into detergent.
2.
Clean or replace filter/detergent siphoning tube.
3.
See "Check In-Line Filter".
4.
Replace spray tip with low pressure spray tip.
Fill fuel tank.
16
advertisement