Backside. SHOWTEC 60449
Add to My manuals16 Pages
SHOWTEC 60449 is a Mirrorball Motor DMX 2 channel.
advertisement
Mirrorball Motor DMX 2 channel
Backside
Fig. 02
07) 3-pin DMX signal connector IN
08) 3-pin DMX signal connector OUT
09) Schuko light fixture 60W OUT # 2
10) Ground/earth connection
Installation
Remove all packing materials from the Mirrorball Motor DMX 2 channel. Check if all foam and plastic padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Ordercode: 60499 8
advertisement
Related manuals
advertisement
Table of contents
- 3 Warning
- 3 Safety Instructions
- 5 Operating Determinations
- 5 Rigging
- 6 Connection with the mains
- 7 Return Procedure
- 7 Claims
- 8 Description of the device
- 8 Features
- 8 Frontside
- 9 Backside
- 9 Installation
- 9 Set Up and Operation
- 10 Control Modes
- 10 One Mirrorball Motor (Stand-alone)
- 10 Multiple Mirrorball Motors (Master / Slave Control)
- 11 Multiple Mirrorball Motors (DMX control)
- 13 Fixture Linking
- 13 Data Cabling
- 13 DMX Channels
- 13 2 Channels
- 14 Maintenance
- 14 Troubleshooting
- 14 No Light
- 15 Product Specifications