F5: ADM. ATEN CS228

4. OSD Operation

F5: ADM

F5 allows an Administrator to configure the OSD operation of the Console. To change a setting double-click it; or use the up and down arrow keys to move the highlight bar to it then press [Enter].

After you select an item, a submenu with further choices for you to select from appears. Double-click the choice you want, or move the highlight bar to then press [Enter]. An icon appears before the selected choice so that you know which one it is. The settings are explained in the following table:

Setting

SET ACCESS

TIMEOUT

Function

This function is used to set the timeout value to control the release of access rights to a computer. If the original Console doesn?t access the computer before the timeout value is reached, the computer becomes available to the other

Console. To set the timeout value, key in a number from 1 -

255 seconds, and then press [Enter]. If the number is 0, this function is disabled. The default is 2 seconds.

This function clears the port name list.

CLEAR THE NAME

LIST

RESTORE DEFAULT

VALUES

RELEASE ALL

PRIVATE

This function is used to undo all Administrator changes and return the setup to the original factory default settings except for the Names that were assigned to Ports, which are saved.

Releases all Ports that have been set to Private Mode (see

PRIVATE MODE, page 23), so that they become accessible

to all Consoles.

21