Harbinger POWERED LOUDSPEAKERS

V2212 & V2215

TM

POWERED LOUDSPEAKERS

QUICK START GUIDE

SETTING UP / HELPFUL TIPS

• Position the VâRi speaker in the desired location, and ensure the speaker is stable.

• Make sure the Power Switch is OFF.

• Make certain Input Gain 1 & 2, and Master Volume are down.

MAKING THE CONNECTIONS

• Plug connections to Input 1. Check that the Mic/Line switch matches the source (Mic for microphones and instruments, Line for mixers, keyboards, or instruments with active pickups).

• Plug connections to Input 2. Note that Input 2 is a Line Input, and will not work well with a microphone.

• Plug connection to Aux In on mobile audio device or computer.

POWERING UP

• Turn on the power to any devices plugged into Input 1, Input 2, or

Aux Input.

• Power ON the speaker.

• Slowly turn the Master Volume to 12 o’clock.

• Slowly turn up the volume of the mobile audio device to the desired level.

• Turn Input 1 to the desired level.

• Turn Input 2 to the desired level.

CLIP LIGHT - LOCATED ON FRONT BEHIND GRILLE

• The SIG/CLIP LED will light up BLUE when the speaker is receiving a signal. If it is distorting, the LED will turn RED and the MASTER

VOLUME should be turned down.

FLOOR MONITOR APPLICATIONS

• Turn the Low EQ down slightly to reduce unwanted rumble and low-frequency build-up. This will reduce feedback and make vocals clearer.

LINKING MULTIPLE SPEAKERS

• If linking multiple speakers, plug the Line OUT connection of

Speaker 1 to the Line In connection of Speaker 2, and continue the daisy chain to the last speaker. (This is common where multiple monitor mixers share the same feed from the mixing board.)

• Turn the Power On in the order of the audio signal to prevent unwanted “pops”. First On / Last Off.

VâRi Series speakers can be used as Main Speakers or Monitor Speakers.

Main

Monitor

Speaker stand not included

5

V2212 and V2215 Owner's Manual