advertisement
9
1 2
V2212 & V2215
TM
POWERED LOUDSPEAKERS
VâRi SERIES BACK PANEL
3 4 5 6 10
7
8
11
1 FRONT LED
The front-mounted LED has two functions. This switch toggles between those functions.
– ON position = Front-mounted LED indicates when power is on.
– S/L position = Front-mounted LED indicates when the limiter is engaged. (If LED turns red in this position, the speaker is distorting.)
2 MIC/LINE INPUT
The Mic/Line input features a balanced XLR jack, and balanced/ unbalanced TRS (tip/ring/sleeve) ¼” jack. Set the Mic/Line button to match the input device to prevent distortion. Unbalanced
¼” instrument jacks may be used here (start with the button in Line setting. If the gain is too low, turn the volume down, select Mic, and slowly raise the volume). For best results, use only the XLR or ¼” jack, not both.
3 LINE INPUT
The Line input features a balanced XLR jack, and an unbalanced RCA jack. For best results, use only the XLR or RCA jack, not both.
4 2 BAND EQ
The LOW EQ will provide +/- 12dB of boost or cut below 100Hz.
Turn the LOW EQ up to add bass or warmth to the speaker. Turn the LOW EQ down to remove rumble and noise when the program material does not contain low frequencies, or when using the speaker as a floor monitor.
The HIGH EQ will provide +/- 12dB of boost or cut above 10kHz.
Turn the HIGH EQ up to add clarity and definition to vocals, acoustic instruments, or backing tracks. Turn the HIGH EQ down to reduce hiss or feedback.
6
5 SIG/CLIP LED
The SIG/CLIP LED will light up BLUE when the speaker is receiving a signal. If it is distorting, the LED will turn RED and the MASTER
VOLUME should be turned down.
6 POWER LED
The Power LED indicates that the VâRi speaker’s AC power cord is connected to an electrical outlet, and the Power Switch is turned on.
7 MASTER VOLUME
The Master Volume controls the overall volume of all 3 inputs.
8 LINE OUTPUT
The Line Output is used to link multiple speakers together using the same audio signal. Connect the Line Output of the first speaker to the
Line Input of the next speaker in the signal path.
9 AUX INPUT
1 /
8
” Stereo input for connecting mobile audio devices to VâRi 2000
Series speaker. Note the Aux Input feeds directly to the Master
Volume control, and does not have an input gain adjustment. For best results, adjust the volume on the device to the desired level, then set the Mic/Instrument, Line Inputs, and Master Volume level.
10 POWER SWITCH
Turn the VâRi speaker ON or OFF.
11 IEC POWER INPUT AND FUSE CARRIER
The IEC AC cable plug inserts into this jack. This is also where the main fuse housing is located.
V2212 and V2215 Owner's Manual
advertisement