24
TIMER TO CLOSE FEATURE (TTC)
Door may operate unexpectedly, therefore do not allow anything to stay in the path of the door.
(IR Beams) to be installed.
TM
Operation: figure 1
Indicator LED figure 2
Indicator LED
Door Fully Closed
To Activate TTC, or change a preset time:
1.Start with the door fully CLOSED.
2.Enter into TTC Activation mode by pressing both PROG and DOWN buttons together for 3 seconds (figure 2).
Release when the courtesy light flashes twice.
3.Press the UP button once for each 10 second increment required of TTC (figure 3. eg. twice for 20 seconds). Press the DOWN arrow to reduce, if needed.
4.Press and release the PROG button to save this time
(figure 4), Courtesy light will flash once. TTC is now activated.
TEST: Operate the door to the UP position. Keep clear of the
IR Beams and check the door closes after the preset time.
To Deactivate TTC:
1.Enter into TTC Activation mode by pressing both PROG and DOWN buttons together for 3 seconds (figure 2).
Release when the courtesy light flashes twice.
2.Press and release the PROG button to save (figure 4), courtesy light will flash once. TTC is now deactivated.
figure 3 figure 4 figure 5
Indicator LED
Indicator LED or
25
INSTALLING YOUR E138M WIRELESS WALL BUTTON
NOTE: The wall control supplied with your opener should be pre-programmed by the factory.
If adding a new wall control, program into the opener before mounting the unit as detailed in Wireless Programming.
Disconnect power to the opener before installing this accessory to prevent accidental activation.
Locate minimum 1.5 m above the floor.
To install:
• Carefully pry open the E138M and locate the two screws for mounting.
• Attach to the wall using the two screws provided. If mounting to a plaster wall, wall plugs may be required.
NOTE: Do not overtighten screws.
• Replace the front cover plate.
+
14
