8. Click Next.
Configuring the iNEWS Command Server
9. When the Ready to Install the Program dialog box appears, click Install.
10. When the installation is complete, click Finish.
To verify that installed services are running, you must use the Avid Service Framework
Workgroup Properties application.
Configuring the iNEWS Command Server
After installation, some configuration is required on each iNEWS Command Server. This section covers defining the password for system administrators, configuring the system name, and some services—such as the Time Synchronization and AirSpeed device services.
Configuring the System Administration Password
Modifying system settings in Avid iNEWS Command requires an administrator password (if set), which is configured through the Service Configuration application of Avid Service
Framework.
47
Configuring the iNEWS Command Server
To change or set up the system administration password:
1. Click the Start button, and then select All Programs > Avid > Service Framework > Avid
Service Configuration.
2. On the Hosts tab, navigate to and select the Avid System Configuration Service.
3. Select the Administrator Password tab.
4. Type in an alphanumeric password and retype it.
5. Click Apply.
n
Click the Reset button to restore to password to the default “blank” password.
48
