Configuring Avid Workgroup Properties
Configuring Avid Workgroup Properties
If the Thunder device is in a different subnet than the Command Servers, you must add the server names to the Lookup tab in Avid Workgroup Properties on the Thunder.
To configure Avid Workgroup Properties:
1. Click the Start button, and then select All Programs > Avid > Service Framework > Avid
Workgroup Properties.
2. On the Lookup tab, click the Add button under the Workgroup section.
The Add Workgroup dialog box will open on top of the Avid Workgroup Properties window, as shown:
3. Enter the name of the workgroup.
4. Click OK. The name you entered will appear in the Workgroup section of the Avid
Workgroup Properties window.
5. Click the Add button under the Lookup services section (above the Apply button).
The Add Lookup Service dialog box will open on top of the Avid Workgroup Properties window, as shown:
198
