DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Chapter 13 Command Logging Command List
enable command logging disable command logging show command logging
13-1 enable command logging
Description
This command is used to enable the command logging function. This is disabled by default.
NOTE: When the Switch is under booting procedure, all configuration command should not be logged. When the user under AAA authentication, the user name should not changed if user uses “enable admin” command to replace its privilege.
Format enable command logging
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To enable the command logging function:
DGS-3000-26TC:admin#enable command logging
Command: enable command logging
Success.
DGS-3000-26TC:admin#
13-2 disable command logging
Description
This command is used to disable the command logging function.
Format disable command logging
Parameters
None.
127
DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Restrictions
Only Administrators can issue this command.
Example
To disable the command logging:
DGS-3000-26TC:admin#disable command logging
Command: disable command logging
Success.
DGS-3000-26TC:admin#
13-3 show command logging
Description
This command is used to display the Switch’s general command logging configuration status.
Format show command logging
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To show the command logging configuration status:
DGS-3000-26TC:admin#show command logging
Command: show command logging
Command Logging State : Disabled
DGS-3000-26TC:admin#
128
