DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Chapter 35 Flex Link Command List
create flex_link group_id <value> primary_port <port> backup_port <port>
delete flex_link group_id <value>
show flex_link {group_id <value>}
35-1 create flex_link group_id
Description
This command is used to create a Flex Link group, and define a port or the master port in a link aggregation group as the primary or backup port in the Flex Link group.
NOTE: Flex Links does not interact with STP or LBD.
Format create flex_link group_id <value> primary_port <port> backup_port <port>
Parameters
<value> - Enter the group ID of the Flex Link. The value is from 1 to 4.
primary_port - Specify a port or the master port in a link aggregation group to act as the primary port in the Flex
Link group.
<port> - Enter a port to be the primary port in the Flex Link group.
backup_port - Specify a port or the master port in a link aggregation group to act as the primary port in the Flex
Link group.
<port> - Enter a port to be the backup port in the Flex Link group.
Restrictions
Only Administrators, Operators and Power users can issue this command.
Examples
To create a Flex Link group:
DGS-3000-26TC:admin#create flex_link group_id 1 primary_port 1 backup_port 2
Command: create flex_link group_id 1 primary_port 1 backup_port 2
Success.
DGS-3000-26TC:admin#
35-2 delete flex_link group_id
Description
This command is used to delete a Flex Link group. When the link aggregation group is removed, the master port of that link aggregation group will still remain the primary or backup port of the Flex Link group.
Format delete flex_link group_id <value>
332
DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Parameters
<value> - Enter the group ID of the Flex Link. The value is from 1 to 4.
Restrictions
Only Administrators, Operators and Power users can issue this command.
Examples
To remove a flext link group:
DGS-3000-26TC:admin#delete flex_link group_id 1
Command: delete flex_link group_id 1
Success.
DGS-3000-26TC:admin#
35-3 show flex_link
Description
This command is used to display Flex Link configuration.
Format show flex_link {group_id <value>}
Parameters
group_id - (Optional) Specify the group ID of the Flex Link.
<value> - Enter the group ID of the Flex Link. The value is from 1 to 4.
Restrictions
None.
Examples
To display the Flex Link configuration:
DGS-3000-26TC:admin#show flex_link
Command: show flex_link
Group Primary Port Backup Port Status(Primary/Backup)
----- ----------------------- ----------------------- --------------------------
1 1 2 Active/Inactive
Total Entries:1
DGS-3000-26TC:admin#
333
