Transfer in and out the wheelchair. Vermeiren Eclips XXL

Eclips XXL

2013-04

To open and remove the arm support:

1.

2.

3.

Pull lever and pull the front of the arm support upwards.

Fold the arm support backwards.

(Fig C)

To remove the arm support, pull the rear of the arm support from tube hood . (Fig D)

C D

2.6 Transfer in and out the wheelchair

L CAUTION: In case you cannot perform the transfer in a safe manner, ask someone to assist you.

L CAUTION: Risk of tipping over of the wheelchair – Do not stand on the footplate.

1. Position the wheelchair as close as possible to the chair, couch or bed to/from you wish to transfer.

2. Check both brakes from the wheelchair are in the on position.

3. Fold the footplate upwards to prevent standing on them or remove the footrest on that side (see § 2.3)

4. If the transfer is on the side of the wheelchair, fold the arm support on that side upwards.

(see § 2.5)

5. Transfer to/from the wheelchair.

2.7 Correct position in the wheelchair

Some recommendations for a comfortable use of the wheelchair:

•

Position your backside as close as possible to the back rest.

•

Make sure your upper legs are horizontal – If needed adjust the length of the footrests. (see § 3.6.1)

Page 9