advertisement
ENGLISH
29
6.3
Defrosting the refrigerator
6.4
Replacing the carbon filter
To get best performance the carbon air filter should be changed once every year.
New active air filters can be purchased from your local dealer.
Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a drain hole into a special container at the back of the appliance, over the motor compressor, where it evaporates.
It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside.
Use the special cleaner provided, which you will find already inserted into the drain hole.
Refer to “Installation of the carbon air filter” for the instructions.
The air filter is a consumable accessory and as such is not covered by the guarantee.
7.
TROUBLESHOOTING
During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service.
The operation of the appliance goes with certain sounds (compressor and circulating sound).
This not means a trouble, but a normal operation.
Problem
The appliance is noisy.
Possible cause
The appliance is not supported properly.
The buzzer sounds.
The Alarm icon flashing.
The door is not closed correctly.
The appliance operates discontinuously, so the stopping of compressor does not mean being no current. That is why you must not touch the electrical parts of the appliance before breaking the circuit.
Solution
Check if the appliance stands stable (all feet and wheels should be on the floor). Refer to "Levelling".
Refer to "Door open alarm".
30 www.aeg.com
Problem
upper or lower square is shown in the temperature display.
“dEMo” appears on the display.
The compressor runs continuously.
Water flows inside the refrigerator.
Water flows on the ground.
Possible cause
An error has occurred in measuring the temperature
The appliance is in demonstration mode.
Solution
Call your service representative (the cooling system will continue to keep food products cold, but temperature adjustment will not be possible)
Keep pressed approximately 10 sec the OK button since a long sound of buzzer is heard and the display shut off for a short while: appliance start works regularly.
Set a warmer temperature.
The Temperature regulator may be set incorrectly.
The door is not closed correctly.
The door has been opened too frequently.
The food temperature is too high.
The room temperature is too high.
The water outlet is clogged.
Food prevent that water flows into the water collector.
The melting water outlet does not flow in the evaporative tray above the compressor.
The Temperature regulator may be set incorrectly.
Refer to "Closing the door".
Do not keep the door open longer than necessary.
Let the food temperature decrease to room temperature before storage.
Decrease the room temperature.
Clean the water outlet.
Make sure that food do not touch the rear plate.
Attach the melting water outlet to the evaporative tray.
Set a warmer temperature.
The temperature in the appliance is too cold.
The temperature in the appliance is too warm.
The Temperature regulator may be set incorrectly.
The door is not closed correctly.
The food temperature is too high.
Set a lower temperature.
Refer to "Closing the door".
Let the food temperature decrease to room temperature before storage.
advertisement
Related manuals
advertisement