TROUBLESHOOTING. Electrolux GA60SLI221X, GA60SLI221

ENGLISH 69

6.

Assemble the filter ( A ) and put it into position in filter ( B ). Turn it clockwise until it locks.

An incorrect position of the filters can cause bad washing results and damage to the appliance.

9.2

Cleaning the spray arms

Do not remove the spray arms.

If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object.

9.3

External cleaning

Clean the appliance with a moist soft cloth.

Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads or solvents.

10.

TROUBLESHOOTING

The appliance does not start or it stops during operation.

Before you contact the Service, refer to the information that follows for a solution to the problem.

With some problems, an intermittent acoustic signal operates and the display shows a message.

Problem

You cannot activate the appliance.

The programme does not start.

The appliance does not fill with water.

WARNING!

Deactivate the appliance before you do the checks.

Possible solution

Make sure that the mains plug is connected to the mains socket.

Make sure that there is not a damaged fuse in the fuse box.

Make sure that the appliance door is closed.

The display shows the message Close the door .

Press the OK touchpad.

If the delay start is set, cancel the setting or wait for the end of the countdown.

Make sure that the water tap is open.

70 www.electrolux.com

Problem

10.1

If the washing and drying results are not satisfactory

Possible solution

Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority.

Make sure that the water tap is not clogged.

Make sure that the filter in the inlet hose is not clogged.

Make sure that the inlet hose has no kinks or bends.

Make sure that the sink spigot is not clogged.

The appliance does not drain the water.

Make sure that the drain hose has no kinks or bends.

Close the water tap and contact the Service.

The anti-flood device is on.

After the checks are completed, activate the appliance. The programme continues from the point of interruption.

If the problem occurs again, contact the

Service.

If the display shows other messages, contact the Service.

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the cause.

• The quality of the combi detergent tablets can be the cause. Try a different brand or activate the rinse aid dispenser and use rinse aid together with the combi detergent tablets.

Refer to ‘HINTS AND TIPS’ for other possible causes.

Whitish streaks or bluish layers on glasses and dishes

• The released quantity of rinse aid is too much. Adjust the rinse aid selector to a lower position.

• The quantity of detergent is too much.

Stains and dry water drops on glasses and dishes

• The released quantity of rinse aid is not sufficient. Adjust the rinse aid selector to a higher position.

• The quality of the detergent can be the cause.

Dishes are wet

• The programme is without a drying phase or with a low temperature drying phase.

Activating the rinse aid dispenser with the multitab option activated

1.

Press the on/off button to activate the appliance.

2.

Open the menu option.

3.

Go to Settings .

4.

Press OK to open the submenu.

5.

Go to Rinse aid and activate the rinse aid dispenser.

6.

Press OK to confirm.

7.

Press the display touchpad to close the menu option.