Servicing the Fuel Filter. Toro Commercial Walk-Behind Mower, Fixed Deck, T-Bar, Gear Drive

1.

Fuel shut-off valve

Figure 31

2.

Clamp

Servicing the Fuel Filter

Replacing the Fuel Filter

Never install a dirty filter if it is removed from the fuel line.

Note: Note how the fuel filter is installed in order to install the new filter correctly.

Note: Wipe up any spilled fuel.

1. Disengage the PTO and set the parking brake.

2. Stop the engine, remove the key, and wait for all moving parts to stop before leaving the operating position.

3. Close fuel shut-off valve at the fuel tank (Figure 31).

4. Squeeze the ends of the hose clamps together and

slide them away from the filter (Figure 32).

5. Remove the filter from the fuel lines.

6. Install a new filter and move the hose clamps close to the filter.

7. Open fuel shut-off valve at fuel tank (Figure 31).

8. Check for fuel leaks and repair if needed.

9. Wipe up any fuel that spilled.

1.

Hose clamp

2.

Fuel line

Figure 32

3.

Filter

29