MOTOR RESET SWITCH. Porter-Cable PXCMLC3706056

MOTOR RESET SWITCH AND WIRING

I WARNING

Ensure that all guards and shrouds are in place before pressing the reset switch to restart the motor.

If the motor shuts down because of overload, wait 10–15 minutes so the motor can cool down, then press ( NEVER force ) the reset switch (see A ) to restart the motor (see Fig. 5 ).

Note: On stationary models not supplied with a power cord, the electrical power must be wired into the pressure switch by a Licensed Electrician.

Fig. 5

A

OPERATING INSTRUCTIONS

BREAK-IN OF THE PUMP

(Fig. 6)

1. Make sure the power is connected at the power panel.

2. Check the oil level in the pump (see “Checking the Oil” in the maintenance

section).

3. Open the petcock (see F ).

I WARNING

Escaping air and moisture can propel debris that may cause eye injury. Wear safety goggles when opening petcock.

4. Turn ON the main power disconnect switch. Turn the pressure switch to the

AUTO position (see D ). The motor should start. Allow the compressor to run for 30 minutes, to break in the internal parts.

NOTE: After about 30 minutes, if the unit does not operate properly, SHUT

DOWN IMMEDIATELY, and contact a qualified service center. DO NOT return the unit to the store where it was purchased.

5. Shut OFF the main power disconnect. Close the petcock (see E ). Connect your air hose(s) to the tank outlet(s).

NOTE: As compressed air is used, the pressure switch will restart the motor automatically to supply more compressed air to the tank.

12- ENG

Fig. 6

F

OPEN

CLOSE

E

13 - ENG