Selecting the Drive Mode. Canon 2249C002

i

Selecting the Drive Mode

Single and continuous drive modes are provided.

1

Press the <

Q

> button.

X The Quick Control screen will appear.

2

Select [ ].

Press the < Y > < Z > keys to select

[ ], then press < 0 >.

3

Select the drive mode.

Press the < Y > < Z > keys to select the desired drive mode, then press

< 0 >.

u : Single shooting

When you press the shutter button completely, only one shot will be taken.

i : Continuous shooting (Max. approx. 5.0 shots/sec.)

When you press the shutter button completely, the camera will shoot continuously while you keep holding it down.

B : Silent single shooting N

When you press the shutter button completely, only one shot will be taken quietly.

M : Silent continuous shooting (Max. approx. 2.5 shots/sec.) N

When you press the shutter button completely, the camera will shoot continuously quietly while you keep holding it down.

123

i Selecting the Drive Mode m / Q : 10-sec. self-timer/remote control (when Wireless Remote

Control BR-E1 (sold separately) is used) l : 2-sec. self-timer q : Self-timer: Continuous

For self-timer shooting, see page 125. For remote control

shooting with the BR-E1, see page 382.

124 i : The approx. 5.0 shots/sec. maximum high-speed continuous shooting speed is achieved under the following conditions*: 1/500 sec. or faster shutter speed, maximum aperture (varies depending on the lens), fully charged battery pack, and room temperature (23°C / 73°F). The continuous shooting speed may become slower depending on the shutter speed, aperture, subject conditions, brightness, lens, flash use, temperature, power source, remaining battery level, etc.

* With the AF mode set to One-Shot AF and the Image Stabilizer turned off when using the following lenses: EF300mm f/4L IS USM, EF28-135mm f/3.5-

5.6 IS USM, EF75-300mm f/4-5.6 IS USM, EF100-400mm f/4.5-5.6L IS

USM.

With Live View shooting, the < B > and < M > cannot be set.

The continuous shooting speed may become slower if the remaining battery level is low or if you shoot under low-light conditions.

In AI Servo AF operation, the continuous shooting speed may become slightly slower depending on the subject conditions and the lens used.

When internal memory becomes full during continuous shooting, the continuous shooting speed may drop off because shooting will be temporarily disabled.

When the camera is paired with BR-E1, < m > will change to < Q >

(p.382).