2.2. Main Unit, LED Indicator and Connector Functionality. Eldes ESIM384

2.2. Main Unit, LED Indicator and Connector Functionality

Main Unit Functionality

GSM MODEM GSM network 850/900/1800/1900MHz modem

SIM CARD1

SIM CARD2

Primary SIM card slot / holder

Secondary SIM card slot / holder

DEF

USB

FUSE F1

W-LESS ANT

GSM/GPRS ANT

Pins for restoring default settings

Mini USB port

2A fuse

Wireless antenna SMA type connector

GSM/GPRS antenna SMA type connector

MODULES* Slots for EPGM8 module

W-LESS ANT

DEF

PRG

USB

Z1 CO Z2 Z3 CO Z6 Z7

LED Functionality

NETW GSM network signal strength

C1

C2

PGM output C1 status - ON/OFF

PGM output C2 status - ON/OFF

C3

C4

STAT

PGM output C3 status - ON/OFF

PGM output C4 status - ON/OFF

Micro-controller status

NETW indication

OFF

Flashing every 3 sec.

Flashing every 1 sec.

Flashing several times per sec.

Steady ON

GSM signal strength

No GSM signal

Poor

Medium

Good

Excellent

Z1 - Z8

Y

G

COM

BELL-

BELL+

AUX-

AUX+

AC/DC

AKU-

Connector Functionality

TIP* PSTN (landline) terminal

RING*

DATA

PSTN (landline) terminal

1-Wire interface for iButton key and temperature sensor connection

+5V

BUZ-

BUZ+

C1 - C4

Temperature sensor power supply terminal (+5V)

Buzzer negative terminal

Buzzer positive terminal

PGM output terminals

Security zone terminals

RS485 interface CLOCK terminal (yellow wire)

RS485 interface DATA terminal (green wire)

Common return terminal

Siren negative terminal (Commutated)

Siren positive terminal (Constant voltage)

Negative power supply terminal for auxiliary equipment

Positive power supply terminal for auxiliary equipment

Main power supply terminals

Backup battery negative terminal

AKU+ Backup battery positive terminal

* - implementable ONLY if ESIM384 device hardware version is up to V5.

SIM CARD1

SIM CARD2

GSM/GPRS ANT

1

MODULES

AKU+

AKU-

ESIM384 Installation and Configuration Manual v1.5

EN