Location of Controls
Location of Controls
KX-DT521AL/KX-DT521NZ/KX-DT521SX/KX-DT521UK/KX-DT521X
KX-DT521NE
7
Location of Controls
KX-DT543AL/KX-DT543NZ/KX-DT543SX/KX-DT543UK/KX-DT543X
KX-DT546AL/KX-DT546NZ/KX-DT546SX/KX-DT546UK/KX-DT546X
KX-DT543NE/KX-DT546NE
8
Location of Controls
KX-DT590AL
KX-DT590SX
KX-DT590UK
KX-DT590X
A LCD (Liquid Crystal Display):
KX-DT521: 1 line, KX-DT543: 3 lines, KX-DT546: 6 lines
B Message/Ringer Lamp:
When you receive an intercom call, the lamp flashes green, and on an outside call, the lamp flashes red. When someone has left you a message, the lamp stays on red.
C Flexible CO Buttons: Used to seize an outside line or perform a feature that has been assigned to the key.
D Handset Hook: Keeps the handset stable when the unit is mounted on a wall.
E Headset Jack
F V / S (PAUSE/PROGRAM) (KX-DT521 only): Used to insert a pause when storing a telephone number. This button is also used for programming this unit.
V (PAUSE) (KX-DT543/KX-DT546 only): Used to insert a pause when storing a telephone number.
G
H
(CONF): Used to establish a multiple party conversation.
(MESSAGE) : Used to leave a message waiting indication or call back the party who left the message waiting indication.
I (FLASH/RECALL): Used to disconnect the current call and make another call without hanging up.
J (REDIAL): Used to redial the last dialed number.
9
Location of Controls
K
L
M
(AUTO ANS/MUTE): Used to receive an incoming call in hands-free mode or mute the microphone/handset during a conversation.
(TRANSFER): Used to transfer a call to another party.
(AUTO DIAL/STORE): Used for System/Personal
Speed Dialing or storing programme changes.
N
O
(HOLD): Used to place a call on hold.
(INTERCOM): Used to make or receive intercom calls.
P (SP-PHONE [Speakerphone]): Used for performing hands-free operations.
Q Microphone: Used for hands free conversations.
R Navigator Key: Used to adjust the volume and the display contrast or select desired items.
S ENTER
*1
: Used to assign the selected item.
T Soft Buttons (S1-S4)
*1
: S1-S4 (located from left to right) are used to select the item displayed on the bottom line of the display.
U
EHS (Electronics Hook Switch) Jack *1
V
FWD/DND *1
: Used to switch Call Forwarding or Do Not Disturb on your extension.
W CANCEL
*1 : Used to cancel the selected item.
*1 KX-DT543/KX-DT546 only
10