Installation and Setup. Panasonic KX-DT521, KX-DT543, KX-DT546

Installation and Setup

Installation and Setup

Note

R Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or operation inconsistent with this documentation.

Attaching a KX-DT590 to the KX-DT543/KX-DT546

The KX-DT590 allows 48 additional Flexible CO buttons to be added to this unit. These buttons are used to seize an outside line, make a call using

One-touch Dialing, or perform a feature that has been assigned to the key.

1

Attach the KX-DT590 to your unit with the 2

screws.

*1

*1 Included with the KX-DT590.

Attaching the Stand

KX-DT521

1

Insert the catches of the stand into the hooks located in the unit.

2

Gently push the stand in the direction indicated until it locks into place.The stand will be mounted.

18

Installation and Setup

KX-DT543/KX-DT546/KX-DT590

1

Insert the catches ( 1 ) of the stand into hooks located in the unit.

2

Gently push the stand in the direction indicated until it locks into place. The stand will be mounted in the high position.

Example: KX-DT546

A

Removing the Stand

KX-DT521

1

Remove the stand in the direction indicated while pushing the catches of the stand with both hands as shown.

KX-DT543/KX-DT546/KX-DT590

1

Hold the stand with both hands.

2

Gently rotate the stand in the direction indicated until it is released.

Example: KX-DT546

19

Installation and Setup

Connections

KX-DT521 The telephone line cord

Connect to a PBX.

Connect to: a digital proprietary telephone

— Digital XDP connection

To a handset jack

(handset)

Clamp

Headset jack

KX-DT543/KX-DT546

Clamp

The telephone line cord

Connect to a PBX.

Connect to: a digital proprietary telephone

— Digital XDP connection a single line telephone

— XDP or parallel connection

To a handset jack

(handset)

Headset

EHS jack Headset jack

20

KX-DT590

Installation and Setup

The telephone line cord

Connect to a PBX.

Clamp

Note

R When connecting a headset

The following headsets can be used with this unit. (Not all operations with the headsets can be guaranteed.)

– Wired headsets

Panasonic RP-TCA400, RP-TCA430, KX-TCA400 or KX-TCA430

– EHS headsets (KX-DT543/KX-DT546 only)

For up-to-date information about headsets that have been tested with this unit, please contact your dealer.

http://www.panasonic.net/pcc/support/pbx/

R When connecting cords

Ensure the cords are inserted in the grooves, and are clamped to prevent damage to the connectors.

21