Configuring the live image change interval. Siemens SISTORE MX

Configuring the user interface of the SISTORE MX NVS application software

15.2.4 Configuring the live image change interval

The

Display mode

group field refers

only

to analog video monitors.

Fig. 104

Display mode group field on the System tab

Prerequisites z

At least one LAN camera has been configured and is connected to the

SISTORE MX NVS server. See Section " General information on LAN cameras", z page 45.

The SISTORE MX NVS software has been started.

See Section " Starting SISTORE MX NVS and logging in“, page 17. z

The SISTORE MX NVS software is in configuration mode.

See Section " Opening configuration mode", page 18.

1.

Select the

System

tab.

2.

In the field

Switch camera on video monitor every

select the period after which the view is switched to the next camera.

3.

In the field

Show event on monitor at least

choose how long live images are to be shown during an event.

4.

Select the period after which the next camera group will be displayed in the box

Switch camera group every

.

Switching times can be selected between 2 and 600 seconds.

5.

Click

Apply

.

Î

The setting will be saved.

15.2.5 Blanking the event view window

When this option is activated, the event view window will be blanked after the preset post-event recording time has expired (see Section 16.4 Configuring recording modes). This means that the camera picture is displayed only during the alarm and the preset post-event recording time.

1.

Select the

Multi-monitor

tab.

2.

Mark the checkbox

Event view window blanked after

.

3.

Set the number of seconds after which the event view window is to be blanked using the arrow buttons.

4.

Click

Apply

.

Î

Your settings will be saved.

114

Siemens Building Technologies

Fire Safety & Security Products 03.2009