Configuring multi-monitor mode. Siemens SISTORE MX

SISTORE RemoteView

25.13 Configuring multi-monitor mode

In order to use multi-monitor mode, the monitors must be configured in Windows:

Start > Control

Panel > Display > Settings

. Please note that the configuration of the monitors in Windows can only be changed when the SISTORE MX NVS application software is closed.

Siemens Building Technologies

Fire Safety & Security Products

Fig. 180

SISTORE RemoteView – Multi-monitor tab

SISTORE RemoteView supports up to 4 monitors. The individual monitors can be configured as: z

Main monitor

See Section 25.13.1 Configuring a monitor as the main monitor. z

Display monitor z

See Section 25.13.2 Configuring a monitor as a display monitor.

Event monitor

See Section 25.13.3 Configuring a monitor as an event monitor. z

Site plan monitor

See Section 25.13.4 Configuring a monitor as a site plan monitor. z

Message dialog monitor

See Section 25.13.5 Configuring a monitor as a message dialog monitor.

213

03.2009