8 LED’s. Beckhoff CB6464

LED’s

8 LED’s

8.1

LED: Powercontroller

There is a RGB LED on the board with which status messages of the power controller are output by means of colors and flashing intervals.

Fig. 9: CB6464 PWRCTRL-LED

 Color

 None

 White

 Cyan

 Magenta

 Blue

 Yellow

 Green

 Red

 Green/yellow

 Red/yellow

 Yellow

 Yellow

 Magenta

 Red/magenta

 Interval

 Steadily lit

 Steadily lit

 Steadily lit

 Steadily lit

 Steadily lit

 Steadily lit

 Steadily lit

 Steadily lit

 Flashing

 Flashing

 Flashing (6s)

 Flashing (3s)

 Flashing (0,5s)

 Flashing

 Meaning

 System in error state

 Power fail

 Reserved

 S UPS active (if existent)

 Reserved

 S5 state

 S0 state

 Reset/Start

 Bootloader running without error

 Bootloader is starting (start sequence is being run

 through)

 S4 state

 S3 state

 S UPS capacitance test (if S UPS exists)

 Checksum error during the I2C transmission in the

 bootloader

A steadily lit red LED can indicate a hardware error.

Adaptation of the status codes

It is possible to adapt the status codes (e.g. as TwinCAT LED). To do this, the system colors can be changed with the aid of an SMB command. This change remains in force until the next restart or reset. A change of the default colors is indicated by the additional flashing of the white LED.

30 Version: 0.4

CB6464