advertisement
2 SpeedTouch™180 Web Interface
2.3.1 Basic Setting
Availability The Basic Setting page is available in all operation modes.
Access Point and
Repeater Mode
Click
Basic Setting
to set the channel, Service Set ID (SSID), and transmit speed for your wireless network.
E-DOC-CTC-20040401-0003 v2.0
The wireless settings are listed in the table below.
Parameter Description
Enable Wireless Networking Enables/disables wireless networking.
Channel The radio channel used for the SpeedTouch™ to communicate with the wireless clients. The Speed-
Touch™ will automatically assign itself a radio channel, or you may select one manually.
The available channel settings might be limited by local regulations.
SSID
SSID broadcast
Transmit Rate
The wireless Network Name. This should be set to the same value as other wireless devices on your network.
The SSID is case sensitive
and can consist of up to
32 alphanumeric characters.
By default the SpeedTouch™180 broadcasts its
Network Name (SSID) to the WLAN clients.
WLAN clients using this broadcast SSID or using an empty SSID can join the SpeedTouch™180.
The transmit rate is automatically adjusted based on the receiving data error rate. Usually the connection quality will vary depending on the distance between the wireless router and wireless clients.
You can also select a lower transmission rate to maximize the radio communication range. (Default:
Automatic)
21
2 SpeedTouch™180 Web Interface
Parameter
Wireless mode
Turbo mode
Description
Select the type of wireless network. The Speed-
Touch™ can support a mixed mode of 11b and 11g,
11g only (11g Turbo).
Enables/disables turbo mode. The turbo mode implemented with the Wireless Access Point can dramatically boost your wireless connectivity.
(Default: Enabled)
Client Bridge mode Click
Basic Setting
to set the Service Set ID (SSID) for your wireless network.
The SSID should be set to the same value as the wireless network that you wish to connect to. It is case-sensitive and can consist of up to 32 alphanumeric characters.
In Client Bridge ad hoc mode, the SSID of both devices needs to be consistent.
22 E-DOC-CTC-20040401-0003 v2.0
advertisement