<b>Installation</b>. SHOWTEC Helix S5000 Q4

Helix S5000 Q4

Installation

Remove all packing materials from the Helix S5000 Q4. Check that all foam and plastic padding is removed. Connect all cables.

Do not supply power before the whole system is set up and connected properly.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Installing the Barndoor (43726)

01) Pull on the spring-loaded locking screws, on both sides of the barndoor, to unlock the mechanism.

Fig. 02

02) Place the barndoor on the Helix, to secure the barndoor’s screws in the Helix’s mounting holes.

03) Release both locking screws to lock the barndoor in position.

Ordercode: 43725 11

Fig. 03