Quick Guide. Canon D30

Quick Guide

See the page indicated ( → ■ ) for more information.

1

Charge the battery pack

Connect the power cord to the adapter, then attach the battery.

When the charge lamp stops blinking and stays lit, the battery is completely charged. A full battery charge takes approximately 90 minutes. ( → 25)

2

Insert the battery pack.

Open the battery chamber cover and slide the battery pack into position until it locks into place.

Press the cover closed until it clicks shut. ( → 27)

5

Mount the lens.

Align the red dots on the lens and camera and turn the lens in the direction shown by the arrow in the diagram until it clicks into place. ( → 30)

6

Set the focus mode switch on the lens to AF.

( → 30)

14

9

Focus on the subject.

Look through the viewfinder and place the AF frame over the subject.

Then press the shutter button down halfway to focus. ( → 33)

● In low-light conditions or backlit daylight conditions, the built-in flash fires automatically. ( → 90)

10

Take the shot.

Press the shutter button down fully. ( → 33)

Quick Guide

3

Open the CF card slot cover.

Slide the cover in the direction shown by the arrow, then open it.

( → 31)

4

Insert the CF card.

Insert the CF card, then close the cover. ( → 31)

7

Set the Main Switch to

⟨

ON

⟩

.

( → 33)

8

Set the Mode Dial to

⟨ ⟩

(Full Auto).

( → 42)

11

Check the image.

The image is displayed for approximately 2 seconds after the shot. ( → 44)

● To check other images you have taken, see “Check the

Image Immediately” ( → 44) and “Viewing Recorded

Images” ( → 102).

● To erase images you have taken, see “Erasing a

Recorded Image (Single

Image Erase)” ( → 47).

15