Selecting a Drive Mode. Canon D30

Selecting a Drive Mode

You can set the EOS D30’s drive mode to single-image shooting, continuous shooting or selftimer operation.

Single-image shooting

⟨ ⟩

: Press the shutter button to take one image.

Continuous shooting

⟨ ⟩

: You can use the continuous shooting mode by pressing and holding the shutter button. The maximum number of images that

Self-timer operation: can be taken for each quality setting is shown in the table below.

You can set the self-timer to take a picture after 10 seconds. ( → 85)

Size/Quality

Large/Fine

Large/Normal

Small/Fine

Small/Normal

RAW

Maximum number of images

(Approx. images/sec.)

ONE SHOT AI SERVO

3 2.5

Maximum number of images

(Approx. images)

ONE SHOT AI SERVO

8

17

17

30

3

● Based on Canon testing standards (shutter speed of 1/250 second or faster, at ISO 100).

● The number of frames that can be recorded depends on the subject and modes used.

1

Press the

⟨

DRIVE

⟩

button.

( ) 6

3

2

Select the drive mode.

● Look at the LCD panel as you turn the

⟨ ⟩ or

⟨ ⟩ dial.

: Single-frame shooting

: Continuous shooting

: Self-Timer Operation

● Press the shutter button down halfway to return to ready-to-shoot mode.

67