TECP-90-708 • Issue 5 • April 2017
Note: When routing a cable from the cable clamp bracket to the splice chassis, bring the cable up in front of the spool and loop the cable back and over the spool then down into the area below the splice chassis as shown in Figure 49 .
BACK
PLATE
REAR VIEW
( S PLICE
CHA SS I S
REMOVED)
25144-A
CABLE ROUTED INTO AREA
BELOW S PLICE CHA SS I S
Figure 49. Routing Cables On Spool Bracket
Note: For instructions on routing the cables into the splice chassis and splice chips, refer to NG4access ODF Platform Splice Chassis and Splice Tray User Manual (TECP-90-
704). This procedure only covers the spool bracket.
4. Slide the splice chassis back into the frame.
5. Re-install the front plate removed in Step 3 on Page 38 .
7 INSTALLING AUXILIARY CABLE SPOOLS (FOR FRAMES WITHOUT SPLICE CHASSIS)
If the frame on which the bracket was just installed does not have a splice chassis (cables will be routed to the universal chassis), auxiliary cable spool brackets (separately ordered) must also be installed. The purpose of these spools is to provide a means for looping the cables over before they are routed into the universal chassis. One kit is required for each universal chassis on the right rear side only. Before the kit can be installed, the vertical cable guide in that location must be removed.
Page 46
© 2017, CommScope, Inc.
TECP-90-708 • Issue 5 • April 2017
Use the following procedure.
1. On the rear side of the frame, remove the vertical cable guide by removing one #12 screw and washer holding the bracket in place. Set aside the screw and washer for use in installing the new bracket. Refer to Figure 50 .
25240-A
Figure 50. Removing the Vertical Cable Guide
2. Install the auxiliary cable spool bracket in the location from which the vertical cable guide was just removed. Refer to Figure 51 and Figure 52 .
Note: Top chassis mounting holes are different than for other chassis in frame. Mount as shown in Figure 52 .
Figure 51. Installing the Auxiliary Cable Spool Bracket
25241-A
Page 47
© 2017, CommScope, Inc.
