advertisement
10.1 Parameter setting in general
Select parameter
1� Press [Enter] briefly�
2� Press [▲] or [▼] until the requested parameter is displayed .
Changing the parameter value
3� Press [Enter] briefly�
> The currently set value is displayed�
4� Keep [▲] or [▼] pressed for 1 s.
> Display flashes first, then permanent�
5� Change value by pressing [▲] or [▼].
Keep [▲] or [▼] pressed.
> Faster cycle of the numerical values�
1 2
3
4 UK
5
Confirm the parameter value
6� Press [Enter] briefly�
> The parameter is displayed again� The new setting value is saved�
6
Finish parameter setting and change to the process value display:
► Wait for 30 seconds or
► Change from the submenu to the main menu, from the main menu to the process value display with [▲] or [▼].
If [C�Loc] is displayed when an attempt is made to modify a parameter value, an IO-Link communication is active (temporary locking)�
If [S�Loc] is displayed, the sensor is permanently locked via software� This locking can only be removed with a parameter setting software�
23
advertisement
