Section 7: Basic Operation. Viotek Gaming Monitor

Section 7: Basic Operation

1. Insert one end of the DP cable into your PC’s graphics card. Other connection types may be used. Additional cables not included.

For optimal refresh rate (or “performance”), it is recommended to use a DP (display port) or HDMI cable with the monitor’s corresponding connector.

2. Connect the other end of the cable to the corresponding connector on your monitor.

DP Connector

HDMI Connectors

3. Connect the power cable to your monitor then connect the other end to your power source. It is recommended that you use a surge protector with adequate voltage if a wall outlet cannot be reached directly.

4. Locate the power button on the monitor and press it to turn the monitor on.

FreeSync

The feature itself is off by default. In order to use this feature, please note you must have hardware with FreeSync capability, a DP or HDMI cable, and the latest graphic drivers. To use this feature, connect your computer and monitor with a DP or HDMI cable. After connecting, you may receive a prompt to enable the feature on your computer. If you do not receive the prompt, you may need to enable the function in your graphics card menu. See your graphics card manufacturer’s documentation for instructions on how to turn on and/or enable FreeSync.

Section 8: Indicator Light

Indicator Light

Solid blue light indicates power is on and the monitor is operating normally. Flashing blue light indicates no video source has been detected. Red light indicates that no horizontal or vertical signal has been detected or voltage is low. Please ensure your computer is on and all video cables are fully inserted and/or connected.

10