advertisement
NOTE: Dryer only. Washer door is not reversible.
REVERSING DRYER DOOR SWING
4. Lift the inner door assembly off outer door assembly.
Remove the Door Assembly
1. Place a towel or soft cloth on top of dryer or work space to avoid scratching of the surface.
2. Remove 3 of the 4 screws that hold the door hinge on the front panel of the dryer. Partially loosen the remaining screw with keyhole opening and lift the door off the screw.
5. Rotate outer door 180°.
3. Lay the door assembly on a previously prepared flat surface with the inside (inner door assembly) facing up, and remove
6 phillips-head screws to release outer door assembly from inner door assembly.
Reverse Hinge
1. Use a small flat-blade screwdriver to remove 2 plug strips from the inner door. Slide the head of the screwdriver under the plugs, without scratching inner door surface, and lift up strip.
2. Remove the 4 screws that attach to inner door hinge.
NOTE: It is important that you remove only 6 indicated screws.
29
REVERSING DRYER DOOR SWING
3. Move hinge to other side. Reinstall 4 screws.
Reverse the strike
1. Use a small flat-blade screwdriver to remove plug strip from the dryer door opening. Slide the head of the screwdriver under the plugs, without scratching dryer surface, and lift up strip.
4. Reinstall plug strips on opposite side of the inner door.
2. Remove the strike using a Phillips screwdriver.
5. Check for fingerprints on the glass. Clean if necessary.
Replace the Door Assembly
1. Place the inner door assembly inside the outer door assembly.
2. Reassemble the inner and outer door assemblies with the
6 screws.
3. Insert strike on the opposite side.
Reinstall the door
1. Partially insert the second screw from the top; then slide the hinge onto this screw while hooking the hinge into the front panel hole. Reattach door to dryer front panel with the remaining three screws.
30
2. Check for fingerprints on the glass. Clean if necessary.
3. Close door and check that it latches securely.
advertisement
Related manuals
advertisement