advertisement
Setup
NOTE: Some or all Setup pages may not be displayed if you do not have the required user permissions.
The device’s factory default settings allow you to use the camera or encoder immediately after installation. If you have special requirements, you can customize the settings through the web interface.
A Restore Default button is available on each Setup page to allow you to restore the factory default settings.
Be aware that some of the settings are only available through the camera web interface and can not be changed in the network video management software.
The following Setup pages in the web interface are common across all Avigilon H.264 devices unless otherwise noted. For the settings that are specific to encoders, see Encoder on page 20.
General
When you select the Setup link, the first page you see is the
General page. The General page allows you to set the device identity.
6
1. In the Name field, give the device a meaningful name.
2. In the Location field, describe the device’s location.
advertisement
Related manuals
advertisement
Table of contents
- 5 Introduction
- 5 System Requirements
- 6 Accessing the Camera Web Interface
- 7 Live View
- 7 Using the Camera Zoom and Focus Controls
- 8 Using Camera Presets
- 8 Using the Encoder PTZ Controls
- 10 Setup
- 10 General
- 11 Network
- 12 Image and Display
- 15 Compression and Image Rate
- 16 Configuring RTSP Stream URI
- 17 Motion Detection
- 18 Privacy Zones
- 19 Digital Inputs and Outputs
- 20 Microphone
- 20 Speaker
- 21 Users
- 21 Adding a User
- 22 Editing Users and Passwords
- 22 System
- 23 Upgrading the Camera Firmware
- 23 Device Log
- 24 Encoder
- 24 Selecting a Port or Channel Option
- 24 Enabling Video Input Termination
- 24 Setting Up PTZ