advertisement
PIC480.241D
24V, 20A, 480W, S
INGLE
P
HASE
I
NPUT PIANO-Series
21.
P
HYSICAL
D
IMENSIONS AND
W
EIGHT
Width
Height
Depth
Weight
DIN-Rail
59mm 2.32’’
124mm 4.88’’
127mm 5.0’’
The DIN-rail height must be added to the unit depth to calculate the total required installation depth.
810g / 1.79lb
Use 35mm DIN-rails according to EN 60715 or EN 50022 with a height of 7.5 or 15mm.
Housing material Body: Aluminium alloy
Cover: zinc-plated steel
Installation clearances
Penetration protection Small parts like screws, nuts, etc. with a diameter larger than 4.5mm
Fig. 21-1 Front view Fig. 21-2 Side view
All dimensions in mm
All dimensions in mm
Dez. 2019 / Rev. 1.0 DS-PIC480.241D-EN (MR1-RP22G) All parameters are typical values specified 230Vac, 50Hz input voltage, 24V, 20A output load, 25°C ambient and after a 5 minutes run-in time unless otherwise noted. www.pulspower.com Phone +49 89 9278 0 Germany
17/20
advertisement
Related manuals
advertisement
Table of contents
- 3 Intended Use
- 4 Installation Instructions
- 5 AC-Input
- 6 DC-Input
- 6 Input Inrush Current
- 7 Output
- 8 Hold-up Time
- 8 DC-OK Relay Contact
- 9 Efficiency and Power Losses
- 10 Functional Diagram
- 10 Front Side and User Elements
- 11 Connection Terminals
- 11 Lifetime Expectancy
- 13 Environment
- 14 Safety and Protection Features
- 15 Dielectric Strength
- 16 Approvals and Fulfilled Standards
- 16 Regulatory Compliance
- 17 Physical Dimensions and Weight
- 18 Accessory
- 18 YR40.242 Redundancy Module
- 18 PIRD20.241 Redundancy Module
- 18 UF20.241 Buffer module
- 19 Application Notes
- 19 Charging of Batteries
- 19 Series Operation
- 19 Parallel Use to Increase Output Power
- 19 Parallel Use for 1+1 Redundancy
- 20 Operation on Two Phases
- 20 Use in a Tightly Sealed Enclosure