PRODUCT OVERVIEW
9
PRODUCT OVERVIEW
Exterior Parts
1
4
5
6
2
3
1 Control Panel & Door Handle
2 Front Cover
3 Lower Cover
4 Shipping Brace
5 Safety Cover
6 SignaLight™ (some models)
7 Base
8 Leveling Feet
7
8
NOTE
• Do not remove the safety cover at any time.
• To ensure reliability, each LG dishwasher goes through thorough quality control before it leaves the factory.
• You may find water droplets or water spots from this process inside your new dishwasher.
SignaLight
™
(Front Display)
The top-control models have 3 indicator LEDs centered at the top of the front cover.
• Red : Error (See the Error Codes in Troubleshooting section.)
• White (steady): Normal operation.
• White (blinking): Cycle has been paused. (After four minutes in pause mode, the machine turns off.)
• Green: Cycle finished normally.
The default “ON” setting keeps the green light on until the door is opened. If the setting is changed to “OFF”, the green light turns off after 90 seconds. To change the setting, turn the power on and press and hold the
High Temp button for 3 seconds until “ON” or “OFF” appears in the display. The setting is stored until you change it.
2
3
4
10
PRODUCT OVERVIEW
Interior Parts
1
5
6
7
8
9
10
1 Top Wash Impeller
2 Upper Spray Arm
3 Lower Spray Arm
4 Filtration System
5 Detergent and Rinse Aid Dispenser
6 Drying Vent Cover
7 Cutlery Rack (some models)
8 Upper Rack
9 Silverware Basket
10
Lower Rack (appearance may vary)
NOTE
• The silverware basket ships installed at the back of the bottom rack. For best performance, install it along the right side as shown in the Interior Parts section.
• Remove all packing materials from the exterior and interior of the dishwasher before installing the appliance.
• Press the tab to remove the cable tie by hand.
Cutting the tie with a knife or scissors may damage the rack or the silverware basket.
3
2
Accessories
Included Accessories
Installation brackets
(2ea)
Wood screws
(4ea)
Hose clamp
(1ea)