UM1774 Getting started
Board package consists of:
•
Hardware: One evaluation board, One USB-UART bridge
• Software: graphical user interface
•
Document: user manual
STAP16DPPS05 evaluation board has on board DC input power supply, 8-bit microcontroller, SWIM connector to program the microcontroller, 32 white LEDs and buttons and potentiometer to change modes and to control brightness and speed, two
STAP16DPPS05 LED driver.
Figure 2. Setup of the board (top)
DocID026418 Rev 1 5/28
28
Getting started
1.
STAP16DPPS05 LED driver
3. Jumpers to simulate open-circuit error detection
4. Jumpers to simulate short-circuit error detection
5. Potentiometer to change brightness and speed
6. SWIM connector: to program microcontroller
7. Push buttons (BCK & FWD): to change different modes
8. DC supply connector: 6-24 V
9. USB-UART bridge: for interfacing board with GUI
10. 32 white LEDs (PLCC 4 ' package)
11. Connector for LIN development and evaluation
12. LF33CDT (low drop out regulator)
Figure 3. Setup of the board (bottom)
UM1774
13. Daughterboard (USB-UART bridge connector)
6/28 DocID026418 Rev 1
