Installing the appliance / appliances. Miele CS1028GSS

Add to My manuals
44 Pages

advertisement

Installing the appliance / appliances. Miele CS1028GSS | Manualzz

Installation

Installing the appliance / appliances

^ Feed the power cord down through the cut-out.

^

Place the front edge of the appliance into the cut-out.

^ With a hand on each side of the appliance press down evenly on the edges until it clicks into position.

When doing so make sure that the appliance seal sits tightly on the countertop to ensure it is sealed correctly. This is important to ensure an effective seal.

Do not permanently seal into the countertop.

When installing more than one appliance, a sealing strip must be inserted into the support bar.

^ Push the installed appliance to the side until the slots in the support bar are visible.

^ Place the front edge of the next appliance into the cut-out.

^

Connect the appliance / appliances to the main power supply (see

"Electrical connection").

^ Turn the appliance / appliances on and check the function.

The appliance may be lifted out using a special tool.

The appliance can also be pushed up and out from underneath.

Note: push the rear out first.

Removing the appliance

If the appliance is accessible from below , it can be pushed up and out of the cut-out. Push up from the back first.

If the appliance is not accessible from below , grip the appliance with both hands at the back, pull forward, then lift it up and out.

^ Insert the sealing strip d into the slots in the support bar b .

33

advertisement

Related manuals